Home / Fluids and filters

BMW Cabin Air Filter: Location and How to Replace It

By Dima · Published November 12, 2026 · Updated November 12, 2026 · 4 min read

Quick answer

On the BMW X5 in these photos, the cabin air filter sits under the dashboard on the passenger side, behind a lower trim panel and a plastic cover held by screws, usually T25 Torx. Depending on the model, the housing takes either one large filter or two small ones. Take off the trim, unplug its connector, remove the cover, swap the filter or filters with the airflow arrow pointing the right way and refit everything.

BMW cabin air filter housing with the cover removed and the filter showing

Where the cabin air filter is

On the X5 in these photos, the cabin air filter is under the dashboard on the passenger side. You reach it through the footwell, behind a lower trim panel and a plastic cover.

In my experience the job is very similar on many BMWs, including the 3, 5, 6 and 7 Series, the M models and the X5 and X7. Some cars have one large filter, others two smaller ones in the same housing, so check before you order parts. Covers and fasteners can differ between generations, so use your own manual as the final word.

What you need

How to replace it, step by step

1. Prepare the footwell

Switch the ignition off and move the passenger seat back. Clear the footwell and have somewhere to put the screws.

2. Release the lower trim panel

The red circles in the photo mark the points where the panel is held. Release them carefully with a plastic trim tool rather than a screwdriver. The two new filters lying on the floor are the ones this car takes.

Lower dashboard on the passenger side with two new cabin filters on the floor and the trim fixing points circled
Red circles mark where the lower trim panel is held. Two new filters lie on the floor.

3. Unplug the connector

There is a wiring connector on the panel (circled). Unplug it before the panel comes away completely, so you don't pull on the wiring.

Lower trim panel removed from the footwell with the wiring connector circled
Panel off. Unplug the circled connector.

4. Remove the cover

The cover over the filter housing is held by screws (circled). On the cars I work with, they are usually T25 Torx. Remove them and lift the cover off.

Cabin filter housing cover with two screws circled in red
The cover screws are circled. They are usually T25 Torx.

5. Take out the old filter or filters

Slide the old filter out and look at the arrow printed on its side, which shows the airflow direction. The new one must go in the same way. If there are two elements, note which one sits where.

Cover removed and the old cabin filter elements partly pulled out of the housing
Cover removed. The old elements slide out of the housing.

6. Clean, fit and close up

Wipe or vacuum the housing before you fit the new filter. Check the arrow direction, refit the cover and its screws without over-tightening the plastic, plug the connector back in, refit the trim and test the fan.

What an old filter looks like

A filter that is dark, clogged with dust and leaves, or flattened has done its job and needs replacing. Weak airflow, a musty smell or windows that clear slowly are the usual signs.

Old dirty cabin air filter lying on a tiled floor
An old filter, dark with dirt. Compare it with a new one before deciding.

How often to replace it

Follow your service schedule, and replace it sooner if you drive on dusty roads or the air smells stale. Many drivers do it about once a year.

Common mistakes

Safety note. Work with the ignition off. If your car has airbags or wiring under the dashboard, take your time and don't pull on cables.

FAQ

Where is the cabin air filter on a BMW?

On the car in these photos, an X5, it is under the dashboard on the passenger side, behind a lower trim panel and a cover. Other models differ, so check your manual.

What size screws hold the cabin filter cover?

On the cars I work with, they are usually T25 Torx. Check yours before you start.

Does the BMW take one filter or two?

Some models take one large filter, others two smaller ones. Check the old one before you buy.

Is the job the same on a 7 Series or an X7?

In my experience it is very similar on many larger BMWs, but covers and fasteners vary, so always confirm with your own manual.

How do I know which way the filter goes?

Look at the arrow printed on the side of the old filter. The new one should point the same way.

This guide is general information based on personal experience, not professional advice. Check your own car's manual for exact specs and read the disclaimer before starting any job.